All cameras, NVRs and DVRs come with a 3-year back-to-base manufacturer warranty covering defects in materials and workmanship, in addition to your rights under Australian Consumer Law. Hard drives and accessories are covered as set out in our Warranty Policy.
Standard shipping is free on all orders over $300 AUD, Australia-wide. Orders under $300 ship at a flat rate of $25, calculated at checkout. Tracking is included on every order.
You have 30 days from the day you receive your order to request a change-of-mind return. Items must be unopened, factory-sealed and in resalable condition. A 15% restocking fee applies and return postage is at your cost. Faulty or incorrectly supplied items are different: we cover the return shipping and refund or replace at no charge. Read the full Return & Refund Policy.
Metro delivery usually takes 2–4 business days after dispatch, and regional areas may take longer. You'll receive a tracking number by email as soon as your order leaves the warehouse.
Products
Bosch DS1101i Glass Break Detector, 7.6 m Sound Analysis
The Bosch DS1101i catches the break-in at the window rather than after it: microprocessor sound analysis listens for the specific frequencies of breaking glass, up to 7.6 m from the glass being protected, and reports on a Form C relay to a hardwired alarm panel.
What you get
- 1 × DS1101i glass break detector in a high-impact ABS enclosure for ceiling or wall mounting
You'll also need
- An alarm panel with a spare zone and a tamper input, supplying 6 VDC to 15 VDC. The ICP-SOL3-P and CC610P are the panels sold here; check their zone inputs against the figures below
- A cable run from the panel carrying its 6 VDC to 15 VDC supply, the alarm relay and the tamper, plus the end-of-line resistors the panel requires
- Motion detectors as well, such as the ISC-BPR2-WP12, because a glass break detector is one component of a perimeter system rather than a system on its own
Bosch DS936 360° Ceiling PIR Detector, 7.5 m Low Profile
The Bosch DS936 is a low-profile ceiling PIR detector for an office, reception or living room that wants a discreet sensor in the middle of the ceiling rather than a box in the corner: a 360° x 7.5 m pattern, a pointable Fresnel lens and normally-closed alarm and tamper outputs for a hardwired panel.
What you get
- 1 × DS936 panoramic PIR detector in a high impact ABS plastic enclosure
You'll also need
- A hardwired alarm panel whose zone input accepts a normally-closed relay and tamper loop, with a 10 VDC to 15 VDC detector supply
- A cable run from the panel to the ceiling position, with the end-of-line resistors the panel requires
- A ceiling position between 2 m and 3.6 m high, or a standard 10 cm (4 in.) octagonal electrical box
Bosch DS9370 360° Ceiling TriTech Detector 14.0 m
The Bosch DS9370 is a ceiling-mounted TriTech motion detector for warehouses, showrooms and open-plan offices where one central point has to watch a full 360° area, combining passive infrared with microwave Doppler radar.
What you get
- DS9370 Classic Line TriTech ceiling detector in white, with its hinged mounting base and modular chassis
- Masking kit with two 120° and two 90° masks for blanking out unwanted areas
You'll also need
- A hardwired alarm control panel whose zone input accepts a Form C relay and a normally closed tamper loop, with a 9 VDC to 15 VDC supply
- A cable run from the panel to the ceiling position carrying power, the alarm relay and the tamper loop
- A ceiling position between 2.4 m and 6.1 m high, or a standard 10.2 cm (3.5 in.) octagonal electrical box
Bosch HCT-4 Four Button Keyfob for the WE800EV2 Receiver
The Bosch HCT-4 is the extra keyfob for a Bosch alarm running a WE800EV2 receiver: four fixed buttons for away arming, stay arming and two relay outputs, with a panic alarm on two buttons held together.
What you get
- 1 × HCT-4 four-button keyfob transmitter, silver
You'll also need
- A WE800EV2 receiver already fitted to the alarm panel, such as the one in the WE800EV2KIT
- An installer or a competent user to learn the new fob into the receiver, which holds a maximum of 21
- A 12VDC 27A battery when the time comes to replace it
Bosch HCT-4UL Four Channel DSRF Keyfob, Designed in Australia
The Bosch HCT-4UL is a four channel DSRF keyfob designed in Australia: away arming with a panic function, disarm, stay arming and an optional fourth channel, in a stainless steel finish with a slide cover so it is not pressed in a pocket.
What you get
- 1 × HCT-4UL four channel keyfob with a slide cover, in a stainless steel finish
You'll also need
- A DSRF receiver on the alarm panel. This fob is only suitable for the RF3212E version of the DSRF receiver, and the RFRC-STR2 is the receiver that replaces the RF3212E
- A CR2032 cell when the low battery warning appears
Bosch ICP-SOL-ENC Steel Enclosure for Solution Alarm Panels
The Bosch ICP-SOL-ENC is the white steel box a Solution panel lives in: room for one control panel PCB, up to six SDI2 modules and two batteries, behind a removable, lockable front door.
What you get
- 1 × ICP-SOL-ENC steel enclosure, white, with a removable mounting plate and a removable lockable front door
- 1 × hardware pack with a tamper bracket for the control panel, an earth cable and screws
You'll also need
- The panel board it is for: the ICP-SOL3-P, the ICP-SOL4-P or the CC610P
- A plug pack and battery, since neither is supplied with the enclosure
- An enclosure tamper switch, which the box is designed to accept
Bosch ICP-SOL3-P Solution 3000 16 Zone Alarm Control Panel
The Bosch ICP-SOL3-P is the Solution 3000 control panel board, the new-generation panel Bosch makes for small residential and commercial sites: 16 fully programmable zones that split into two independent areas, room for four keypads, and phone control once a communicator is added.
What you get
- 1 × ICP-SOL3-P control panel PCB with a built-in PSTN dialler
- Hardware pack: end-of-line resistors, battery wires, PSTN lead and screws
You'll also need
- An enclosure to mount it in, such as the ICP-SOL-ENC
- The TF008 plug pack for primary power and a 12 VDC, 6.5Ah sealed lead-acid battery for backup
- At least one keypad: the IUI-SOL-ICON, the IUI-SOL-TEXT or a touchscreen such as the IUI-SOL-TS5
- Detectors and cable for the zones, and a B426-M or B450-M communicator if the owner wants the phone app
- A WE800EV2 or RADION receiver if wireless devices are part of the system, such as the WE800EV2KIT
Bosch ICP-SOL4-P Solution 4000 32 Zone Alarm & Access Panel
The Bosch ICP-SOL4-P is the Solution 4000 control panel board for a home or small to medium business that wants intrusion and door control in one system: 32 wired or wireless zones, 4 door zones through the B901 door controller, two partitions and 64 user codes.
What you get
- 1 × ICP-SOL4-P control panel PCBA, 1 hardware pack and 1 quick user guide
You'll also need
- A keypad: the IUI-SOL-ICON, IUI-SOL-TEXT, IUI-SOL-TS5 TouchOne Mini or IUI-SOL-TS7
- The ICP-SOL-ENC steel enclosure, a TF008 plug pack and a 12 VDC, 6.5Ah sealed lead-acid battery, all ordered separately
- Detectors for the zones, and a B426-M or B450-M communicator for Email, CSV-IP, push notifications and the RSC+ app
Before you buy
What customers ask most before ordering from this range — and how we deliver.
Which kit is right for me?
Start with three questions: how many areas do you need to cover, do you want colour night vision, and do you want AI alerts that ignore cars and animals? For most homes, a 4-camera 8MP ColorVu or Full-Colour kit is the sweet spot. Not sure? Use our CCTV Advisor — answer a few questions and it recommends a kit — or email us and we'll spec it with you.
Is your Hikvision, Dahua, HiLook and TP-Link VIGI stock genuine Australian stock?
Yes, 100%. Every Hikvision, Dahua, HiLook and TP-Link VIGI product we sell is a genuine Australian-market model sourced through Australian supply chains — never grey imports. That means factory-sealed units, Australian-region firmware that works with the official apps out of the box, and a full 3-year local warranty.
How long does delivery take?
Metro delivery usually takes 2–4 business days after dispatch, and regional areas may take longer. You'll receive a tracking number by email as soon as your order leaves the warehouse.
How much is shipping?
Standard shipping is free on all orders over $300 AUD, Australia-wide. Orders under $300 ship at a flat rate of $25, calculated at checkout. Tracking is included on every order.
What warranty do you offer?
All cameras, NVRs and DVRs come with a 3-year back-to-base manufacturer warranty covering defects in materials and workmanship, in addition to your rights under Australian Consumer Law. Hard drives and accessories are covered as set out in our Warranty Policy.
What is your return policy?
You have 30 days from the day you receive your order to request a change-of-mind return. Items must be unopened, factory-sealed and in resalable condition. A 15% restocking fee applies and return postage is at your cost. Faulty or incorrectly supplied items are different: we cover the return shipping and refund or replace at no charge. Read the full Return & Refund Policy.
Do you offer installation?
We can connect you with licensed installers in Sydney and Melbourne. Installation typically starts from around $200 per camera depending on cable runs and site conditions. Email sales@smarket.com.au with your address and camera count for a quote.
Shop by Brand
Pick your preferred manufacturer ecosystem
Shop by Category
Cameras, recorders, kits and accessories
