Alarm

The Hikvision DS-PM1-O1H-WB is a wireless wall switch for AX PRO alarm systems, with a high-power relay that switches mains circuits directly. Linked to your alarm by 433MHz two-way wireless, it can turn lighting or appliances on and off on an alarm, a schedule or a manual command - no control cable back to the hub.

At a glance
- Single relay output, NO/NC, 100-240V AC up to 13A - switches mains loads directly
- 433MHz two-way wireless (2GFSK) to the AX PRO hub, up to 800m, AES-128 encrypted
- Scenario control: by alarm, by operation, by fault, by schedule or manual
- Mains powered (100-240V AC, 50/60Hz); wall mount or inside a standard 86 box
- Three status LEDs (register/signal, power, relay); licensed electrician required for mains wiring

The Hikvision DS-PDC10DM-VG3 is a wired outdoor dual-tech curtain detector for AX Hybrid Pro and general wired alarm panels. It combines a PIR sensor with a 24GHz microwave sensor that must both agree before it alarms, throwing a narrow 5 degree curtain along a wall, window or balcony to catch an intruder at the perimeter - with far fewer false alarms outdoors.

At a glance
- Wired dual-tech detection: PIR plus 24GHz microwave must both trigger, cutting false alarms
- Narrow 5 degree curtain, 10m on wall mount / 6m on ceiling, 32 zones, directional detection
- Active IR anti-masking alarms if the lens is covered or sprayed
- IP65 weatherproof; -25 to 60 degrees; slim body, L-shaped adapter bracket included
- Normally-closed output with selectable EOL resistors; 9-16VDC; front and rear tamper

The Hikvision DS-PDC10AM-VG3 is a slim wired PIR curtain detector for AX Hybrid Pro alarm systems. It casts a narrow vertical curtain of detection along a window or door, raising the alarm the instant someone breaches that line while letting people move freely inside the room behind it.

At a glance
- Narrow 5-degree PIR curtain beam, 10m wall-mount or 6m ceiling-mount range
- Active IR anti-masking (AM) reports any attempt to spray, cover or block the lens
- 32 detection zones, directional detection and digital temperature compensation
- IP65 rated for both indoor and outdoor use, -10 to 55 degrees C
- Wired: NC alarm output, selectable EOL resistors, front and rear tamper, 9-16 VDC

The Hikvision DS-PDB-IN-Wristband is a wearable holder for an AX PRO portable panic button. Made from skin-friendly rubber, it lets a user wear their emergency button on the wrist for instant access throughout the day - ideal for elderly residents, lone workers and staff who need a duress alert always to hand.

At a glance
- Wrist-worn holder for an AX PRO portable panic button
- Skin-friendly rubber that resists irritation for all-day wear
- Keeps the emergency button within instant reach, hands-free
- Lightweight 15g, dimensions 38 x 255 x 12mm
- Accessory only - the portable panic button is purchased separately

The Hikvision DS-PM1-O4H-H is a wired 4-way power output module for AX Hybrid Pro hardwired alarm controllers. It gives the panel four high-current relays that can switch mains-powered devices - sirens, strobes, lighting circuits, gates and shutters - on command over the Speed-X bus, turning an alarm event into real-world action.

At a glance
- Four onboard power relays, each rated to switch up to 16A
- Connects to a 100-240 VAC source and opens/closes circuits on command
- Controlled by the AX Hybrid Pro panel over the Speed-X bus
- Cascade support: 1 uplink and 1 downlink Speed-X port for more expanders
- Front and rear tamper, plastic enclosure, mains wiring by a licensed electrician

The Hikvision DS-PM1-I1-WB is a wireless input transmitter for AX PRO alarm systems. It bridges one existing wired detector, contact or alarm device into the AX PRO wireless system, so you can reuse proven wired hardware on a modern wireless panel without running new cable back to the hub.

At a glance
- Converts one wired alarm input (PIR, reed, vibration, contact) into a wireless AX PRO zone
- One alarm input, one tamper input, one programmable PGM output, plus a 3.3V output for low-current sensors
- Tri-X two-way wireless on 433MHz (2GFSK), up to 1300m open-air, AES-128
- Three CR123 batteries, up to 5 years; built-in tamper
- Compact module fits inside a wireless-ready detector or beside the wired device

The Hikvision DS-PDEBP2-EG2-WB is a portable wireless dual panic button for AX PRO alarm systems. Pressing both buttons together sends an immediate distress alert to the hub and on to carers' phones through Hik-Connect, while the two-button design helps prevent the accidental presses that catch out single-button buttons in a pocket or bag.

At a glance
- Two-button press sends a wireless emergency / panic alert to an AX PRO hub
- Dual-button design plus accidental-press protection cuts false alerts
- Tri-X two-way wireless, up to 800m open-air, 433MHz, AES-128 with frequency hopping
- Wear on a lanyard or the optional wristband; red / green status LED
- One CR2032 battery, up to 3 years; IP54 splash resistant for everyday use

The Hikvision DS-PDSMK-4BAR is a wired 4-wire photoelectric smoke detector that adds early fire warning to a 12 VDC intrusion or fire alarm system. When smoke enters its sensing chamber, it raises a built-in sounder and signals the connected alarm panel, so an emerging fire is flagged locally and remotely.

At a glance
- Photoelectric smoke sensing for early, low-nuisance fire detection
- 4-wire conventional connection to 12 VDC alarm panels
- Built-in high-output sounder, approximately 85dB at 3m
- Normally Open (NO) or Normally Closed (NC) relay output
- Dual red LEDs with 360-degree visibility, low-profile ceiling mount