Alarm

The Hikvision DS-PT1-WE is a wireless Mifare tag reader for Hikvision AX PRO alarm systems, operating on the 868MHz band. Mount it by a door and users arm or disarm the alarm with a quick swipe of a Mifare tag - no PIN to remember - making everyday operation faster at busy entry points.

At a glance
- Wireless Mifare tag reader for arming and disarming an AX PRO alarm
- 868MHz two-way wireless - must match your AX PRO hub's RF band
- AES-128 encryption and clear multi-colour LED feedback
- Stay arm / away arm / disarm by area, plus patrol tag check-in
- Front and rear tamper, 3 x AA batteries, up to 2 years standby

The Hikvision DS-PDC10AM-EG2-WB is an outdoor curtain PIR detector for AX PRO alarm systems. Its narrow 5° beam forms an invisible curtain along a wall, window line or balcony, catching an intruder at the perimeter - before they reach a door or window - with active anti-masking to stop it being quietly disabled.

At a glance
- Curtain-style PIR detection, narrow 5° beam, 10m wall mount / 5m ceiling mount, 32 zones
- Active IR anti-masking alarms if the lens is covered or sprayed
- IP65 weatherproof; -25 to 60°C; L-shaped adapter bracket included
- Pet immunity up to 12kg (wall mount; none on ceiling mount)
- Tri-X two-way wireless to an AX PRO hub, up to 1km, 433MHz; two CR123A, up to 5 years

The Hikvision DS-PDCL12DT-EG2 is a wired dual-technology ceiling detector that combines PIR with 24GHz microwave for 360-degree coverage out to 12 metres. The two technologies cross-verify movement to cut false alarms, it runs on 9-16VDC with an onboard end-of-line resistor, and it is for indoor ceiling mounting.

At a glance
- Dual-tech: PIR + 24GHz microwave cross-verification, 360-degree, 12m, 172 zones
- Wired detector: 9-16VDC (12VDC typical), 100mA; onboard EOLR (jumper-selectable)
- Grade 2 interior; ceiling mount 2.4m to 4m, indoor
- Digital temperature compensation, sealed optics, creep-zone protection
- Front tamper protection; connects to AX Hybrid Pro or general wired panel zones

The Hikvision DS-PDPC12P-EG2-WB is a wireless PIRCAM detector for AX PRO alarm systems. It combines a passive infrared motion sensor with a built-in camera that captures JPEG snapshots when the alarm triggers, so you or a monitoring centre can see what set it off - turning a bare motion alert into a verified event over a fully wireless link.

At a glance
- PIR motion + built-in camera for image verification (JPEG snapshots on alarm)
- 12m range / 85.9 degree / 52 detection zones; up to 30kg pet immunity
- Polarising IR lens with 12m infrared fill for clearer low-light snapshots
- CAM-X two-way wireless on 433MHz, up to 800m open-air, AES-128
- Three CR123A batteries, up to 6 years; front and rear tamper; indoor wall mount

The Hikvision DS-PDTT15AM-LM-WB is a wireless outdoor Tri-Tech detector for AX PRO alarm systems. By requiring two PIR sensors and a 24GHz microwave sensor to agree before it raises an alarm, it delivers dependable perimeter detection outdoors while shrugging off the weather, wildlife and moving foliage that defeat ordinary sensors.

At a glance
- Tri-Tech detection: dual PIR plus 24GHz microwave with triple-signal logic
- 15m range, 90-degree angle adjustable up to 180 degrees, 92 zones
- Pet immunity up to 40kg and active IR anti-masking
- IP65 weatherproof, -25 to 60 degrees C, anti-sway analytics
- Tri-X two-way 433MHz to 1km, CR123A x5 up to 5 years

The Hikvision DS-PDBG8-EG2 is a wired acoustic glass-break detector for AX Hybrid Pro and general hardwired alarm panels. Its omni-directional microphone listens for the two-stage sound of breaking glass - the impact and then the falling shards - and alarms the moment a window or glass door is smashed, before an intruder is even inside.

At a glance
- Wired acoustic glass-break sensor, 8m range across 120°, potentiometer-adjustable sensitivity
- Detects float, plate, tempered, wired, laminated leaded and double-glazed glass (2.4-6.4mm)
- Normally-closed output with selectable EOL resistors (1K, 2K2, 4K7, 5K6, 6K8)
- 9-16VDC wide-voltage input with reverse-polarity protection; front tamper
- Indoor wall or ceiling mount; Grade 2; for AX Hybrid Pro and general wired panels

The Hikvision DS-PM1-I8O2-H is a Speed-X wired input expander for the AX Hybrid Pro alarm panel. It adds eight on-board wired zones and two collector outputs to a hardwired system, so you can connect more detectors, contacts and output devices than the panel alone supports.

At a glance
- Adds 8 wired zones + 2 outputs to an AX Hybrid Pro (DS-PHA64) panel
- Connects over the Speed-X bus, up to 900m of cable, and cascades to further expanders
- 3EOL wiring (1k alarm / 1k tamper / 2.2k fault) with zone, tamper, mask, fault and short detection
- 11-24VDC input; output 9-12VDC up to 500mA to power wired detectors directly
- Front and rear tamper protection; power and fault LED indicators
- Wired expansion module - not for the wireless AX PRO (PWA96) hub

The Hikvision DS-PK1-LT-WB is a wireless LCD keypad for the AX PRO alarm system, with a backlit LCD screen, full-touch keys and a built-in Mifare tag reader. It arms and disarms by PIN or tag, has one-touch fire, panic and medical keys, and communicates over Tri-X two-way wireless. Available in black or white.

At a glance
- Backlit LCD screen with full-touch keys for clear status and menus
- Built-in Mifare tag reader for tap-to-arm without a PIN
- One-touch fire, panic and medical emergency keys
- Tri-X two-way wireless (433MHz, 2GFSK), up to 800m open-air
- Battery powered (4 x CR123), up to 2 years standby; front and rear tamper