CCTV Accessories

The Hikvision DS-1273ZJ-140-DM45 is a wall mount bracket with an integrated DM45 junction box for Hikvision turret (dome) cameras. The aluminium-alloy arm holds the camera off the wall and the junction box conceals the cable joins, giving a tidy, weather-tolerant install in a sprayed Hikvision White finish.

Key points
- Wall mount arm plus integrated DM45 junction box
- Designed for Hikvision turret / G-series dome cameras
- Aluminium alloy with sprayed Hikvision White finish
- Junction box conceals and protects the cable terminations
- Holds the camera off the wall for a clear downward view
- Suits indoor and outdoor installations

The Hikvision DS-UPS1000 is a 1000VA / 600W uninterruptible power supply (UPS) built to keep CCTV systems running through power cuts and dips. Plug your NVR or DVR - and, where the recorder feeds PoE cameras, the whole camera system - into the DS-UPS1000, and a blackout no longer means lost footage or a recorder that drops out mid-recording.

At a glance
- 1000VA / 600W back-up capacity for recorders and PoE camera systems
- Wide input range with built-in AVR to ride out brown-outs and surges
- 12V/9Ah battery, fast recharge to 90% in about 4-6 hours
- Two AU Type-I outlets, surge, overload, discharge and overcharge protection
- Runtime around 60 min at 60W, 15 min at 150W, 2 min at 300W

The Hikvision DS-1280ZJ-SD11 is an aluminium-alloy junction box that mounts a 4-inch mini PTZ camera and hides the cabling behind it. It suits Hikvision DS-2DE4A series mini PTZ domes, supports up to 5 kg, and offers both side and bottom cable entry so you can run conduit neatly. The weatherproof design suits indoor and outdoor installs when the supplied rubber seal is fitted.

Key points
- Junction box for Hikvision 4-inch mini PTZ cameras (DS-2DE4A series)
- Aluminium alloy with sprayed Hikvision White finish
- Maximum load capacity 5 kg (11 lb)
- Side and bottom cable entry for tidy conduit routing
- Weatherproof design; fit the rubber seal for outdoor use
- Diameter 157.7 mm, depth 39.7 mm; weight 450 g

The Dahua DH-PFA130-E is the larger, IP66-rated aluminium junction box in Dahua's range. It mounts behind turret and dome cameras to give a fully sealed cavity for the network cable and connector, with a higher 3.0 kg load rating and a G3/4 inch conduit entry for heavier or commercial installs.

Key points
- Suits Dahua turret & dome cameras (check the Accessory Selection line on your camera's datasheet)
- IP66 rated — the only box in this range with a stated weatherproof rating
- Aluminium alloy, white finish
- Ø124 mm × 41 mm, approx. 0.35 kg
- G3/4" conduit thread; 3.0 kg load rating

The Dahua DH-PFA139 is a compact aluminium junction box that mounts behind Dahua turret and eyeball cameras. It gives a tidy, sealed cavity to coil and protect the network cable and connector where it enters the camera, instead of leaving the join exposed on the wall.

Key points
- Suits Dahua turret & eyeball cameras (check the Accessory Selection line on your camera's datasheet)
- Aluminium alloy, white finish
- Ø108.0 mm × 28.5 mm, approx. 0.16 kg
- M20 (G1/2") cable gland thread; 1.0 kg load rating
- Designed for weather-resistant outdoor mounting when the entry is sealed

The Dahua DH-PFB203W is an aluminium and steel wall mount bracket that holds a Dahua camera out from a vertical wall and conceals the cable through the arm. It angles a bullet, turret or dome camera over a door, driveway or path where there is no eave to mount under. Dahua has since released the DH-PFB204W as its near-identical replacement.

Key points
- Wall mount bracket for Dahua bullet, turret & dome cameras (check the camera's Accessory Selection)
- Aluminium & SECC steel, white finish
- 160 mm × 122 mm × 76 mm, approx. 0.5 kg
- 1.0 kg load rating; cable concealed through the bracket
- Superseded by the near-identical DH-PFB204W

The Hikvision DS-1260ZJ (factory code CB130) is a compact aluminium-alloy junction box for Hikvision bullet cameras in the 2CD26x2 and 2Tx5 families. It mounts behind the bullet base to conceal and weatherproof the cable entry.

Key points
- Suits Hikvision 2CD26x2 / 2Tx5 bullet cameras (for example DS-2CD2T86G2, DS-2CD2T66G2)
- Aluminium alloy with surface spray treatment
- Ø88.5 mm × 36 mm, approx. 248 g
- Maximum load 4.5 kg
- Available in white or black