Products

The Hikvision DS-PDC10DM-VG3 is a wired outdoor dual-tech curtain detector for AX Hybrid Pro and general wired alarm panels. It combines a PIR sensor with a 24GHz microwave sensor that must both agree before it alarms, throwing a narrow 5 degree curtain along a wall, window or balcony to catch an intruder at the perimeter - with far fewer false alarms outdoors.

At a glance
- Wired dual-tech detection: PIR plus 24GHz microwave must both trigger, cutting false alarms
- Narrow 5 degree curtain, 10m on wall mount / 6m on ceiling, 32 zones, directional detection
- Active IR anti-masking alarms if the lens is covered or sprayed
- IP65 weatherproof; -25 to 60 degrees; slim body, L-shaped adapter bracket included
- Normally-closed output with selectable EOL resistors; 9-16VDC; front and rear tamper

The Hikvision DS-PDCL12DT-EG2 is a wired dual-technology ceiling detector that combines PIR with 24GHz microwave for 360-degree coverage out to 12 metres. The two technologies cross-verify movement to cut false alarms, it runs on 9-16VDC with an onboard end-of-line resistor, and it is for indoor ceiling mounting.

At a glance
- Dual-tech: PIR + 24GHz microwave cross-verification, 360-degree, 12m, 172 zones
- Wired detector: 9-16VDC (12VDC typical), 100mA; onboard EOLR (jumper-selectable)
- Grade 2 interior; ceiling mount 2.4m to 4m, indoor
- Digital temperature compensation, sealed optics, creep-zone protection
- Front tamper protection; connects to AX Hybrid Pro or general wired panel zones

The Hikvision DS-PDCM15PF-IR is a camera module for the AX PRO wireless alarm system. It is not a standalone surveillance camera - it clips onto the AX PRO wireless outdoor Tri-Tech detector and adds visual alarm verification, capturing a short burst of photos when the detector triggers and sending them to the Hik-Connect app and the monitoring centre so a real intrusion can be told apart from a false alarm. Built-in infrared up to 15 m gives images at night, and the module is IP66 for outdoor use.

Key points
- Adds photo verification to the AX PRO wireless outdoor Tri-Tech detector
- Captures a burst of JPEG snapshots on alarm (up to 640 x 480)
- Sends images to Hik-Connect and the monitoring centre (ARC)
- 2 mm lens, 137° horizontal field; colour by day, infrared up to 15 m at night
- IP66 outdoor rated; powered from the detector (3 VDC)
- Requires the AX PRO hub and a compatible wireless Tri-Tech detector
- Not a continuous-video camera and does not connect to an NVR

The Hikvision DS-PDD12P-EG2 is a wired dual-technology indoor detector for AX Hybrid Pro and other hardwired alarm panels. A passive infrared (PIR) sensor and a 24GHz microwave sensor work together and only alarm when both agree, cutting false alarms while still catching movement from the first step.

At a glance
- Wired dual-tech PIR + 24GHz microwave, 12m range / 85.9° / 52 detection zones
- Up to 30kg pet immunity with creep-zone protection and digital temperature compensation
- Normally-closed alarm output with selectable EOL resistors for alarm and tamper
- 9-16VDC wide-voltage input with reverse-polarity protection; front tamper
- Indoor wall mount 1.8-2.4m; optional wall and ceiling brackets

The Hikvision DS-PDMCX-E-WB is a large wireless outdoor magnetic contact (reed switch) for AX PRO alarm systems. With an IP66 housing, a big external magnet and a generous 76mm gap, it brings open/close detection to gates, roller doors, sheds and other outdoor openings where an indoor contact will not cope.

At a glance
- Wireless outdoor open/close detection for gates, roller doors and sheds
- IP66 weatherproof, UV-stable housing; -20 to 60°C operation
- Large external magnet with up to 76mm detection gap for misaligned or wide openings
- Tri-X two-way wireless to an AX PRO hub, up to 1km open-air, AES-128 with frequency hopping
- One CR123A battery, up to 5 years; front and rear tamper; alarm input (NC / NO / impulse)

The Hikvision DS-PDP18-EG2 is a wired indoor PIR motion detector from the AX Hybrid range, giving 18 metres of volumetric coverage from a slim, unobtrusive housing. It uses a dual-element infrared sensor and a 3D Fresnel lens to detect a moving intruder accurately while ignoring everyday nuisances, and its selectable end-of-line resistors let it wire into almost any hardwired or hybrid alarm panel.

Key points
- 18 m volumetric coverage at an 85.9° detection angle
- Dual-element PIR sensor with 3D Fresnel lens optics
- Creep-zone protection covers the blind spot directly below the unit
- Sealed optical chamber resists insects and false triggers
- Selectable EOL resistors (1K/2K2/4K7/5K6/8K2) suit most panels
- 9-16 VDC wired power with reverse-polarity protection
- Optional pet mask for immunity up to 10 kg

The Hikvision DS-PDPC12P-EG2 is a wired PIRCAM detector for AX Hybrid Pro alarm systems. It pairs passive infrared motion detection with a built-in camera that captures JPEG snapshots when the alarm triggers, so you or a monitoring centre can confirm what set it off - turning a bare motion alert into a verified event.

At a glance
- PIR motion + built-in camera for image verification (JPEG snapshots on alarm)
- 12m range / 85.9° / 52 detection zones; up to 30kg pet immunity
- 12m infrared fill light with polarising IR lens for clearer low-light images
- Speed-X wired bus to the panel (up to 1km), AES-128 encrypted; 9-16VDC
- Front and rear tamper; indoor wall mount 1.8-2.4m; Hik-Connect app set-up

The Hikvision DS-PDSK-P is a wired shock detector for AX Hybrid Pro alarm systems. Fitted directly to a door, window, wall or safe, it senses the vibration of drilling, levering or hammering and raises the alarm during a forced-entry attempt - before an intruder actually gets inside.

At a glance
- Shock sensor detects forced-entry vibration on the protected surface
- Adjustable sensitivity via potentiometer, with gross-attack override
- Advanced digital background-noise filter to reduce false alarms
- Wired NC alarm output, front tamper, blue LED indicator
- 9-16 VDC (typically 12 VDC), 30mA, indoor use